Type ‘ sdclt’ in the run box and hit enter to open the Back Up and Restore Window.Press Windows/Start Key + R to open the run window.This will prevent windows from saving the backup files to the HP_Tools partition in the future. Method 1: Stop windows from storing back up data and remove already backed up and personal data from the HP_Tools partition Step 1: Stop windows back up Having pointed out the possible causes of the error, here are the solutions to your problem. You will therefore get the message that your disk is full. Your computer might run out of space when trying to automatically save this data to the HP Tools partition via the Recovery, Back up and Restore, or the HP tools utility. Backup utilities never back up to drive C and, in the case of an HP computer, they will glide beyond D which is the DVD drive and land on E, the Tools partition. A likely case is that these two utilities, or either of them, are saving data into the HP_Tools drive. Another Windows system utility that stores data is the ‘ Back up and Restore’ feature which uses enormous amounts of space. The HP tools utility is not to be confused with ‘ Windows Recovery’ that creates data based on a restoration point in your PC. Windows Recovery or the Backup and Restore utility is storing data into the HP tools partitions: – This is the most likely cause for the message.
This means that the ‘ HP_Tools drive is full’ error will appear whenever the HP Tools utility tries to save data into this partition. You have saved personal data into the HP tools partition: – If you store your personal data into this partition, then sooner or later, the partition is going to fill up.Here are a few causes that might be filling the HP tools partition in your case. So what would drive it to a fully occupied state? The issue is always related to data that is not meant for that drive. The partition is around 100MB and only 20MB is used to store the utilities.īy design, the HP_Tools drive should always be less than a quarter or half full at the worst case. These tools are used to check for failing hard disks, memory etc., which are usually accesses by pressing F11 during booting. The partition houses your computer’s diagnostic tools. This drive usually has the drive letter (E:). The HP_Tools drive is created by the system when the HP Tools utility is installed on your HP computer.
0 kommentar(er)
